FORD BLUE PAINT 750 ML POT

Implementation

Application by brush, roller or spray.

To paint:

For brush application use special brushes with synthetic or mixed bristles.

Roller application:

For roller application, use a brushed foam roller. You can also use a short-haired FILT roller and then roll again with a fine-pored foam roller.

Spray application:

Adapt the consistency of the material. Observe the information from the device manufacturer.

High pressure :

nozzle: 1.5 – 1.8 mm; spray pressure: 3 – 4 bar; dilution: approximately 10%.

Airless application:

spray angle: 50°; nozzle: 0.010 – 0.013"; spray pressure: 130-150 bar; undiluted

Prepare the funds according to the rules of the art. See chapter “Preparing/Printing the media”. To obtain sufficient protection, apply at least 2 coats.

The ambient and object temperatures must be at least +5°C during processing and drying.

Mix well before use.

Too thick a coat and too short drying times between coats can result in wrinkling of the coating surface and prolonged drying times.

Ensure adequate ventilation during processing and drying indoors.

Allow sufficient drying time between coats. The environment of the surfaces to be coated must be covered and protected from

splashes of

Implementation

Application by brush, roller or spray.

To paint:

For brush application use special brushes with synthetic or mixed bristles.

Roller application:

For roller application, use a brushed foam roller. You can also use a short-haired FILT roller and then roll again with a fine-pored foam roller.

Spray application:

Adapt the consistency of the material. Observe the information from the device manufacturer.

High pressure :

nozzle: 1.5 – 1.8 mm; spray pressure: 3 – 4 bar; dilution: approximately 10%.

Airless application:

spray angle: 50°; nozzle: 0.010 – 0.013"; spray pressure: 130-150 bar; undiluted

Prepare the funds according to the rules of the art. See chapter “Preparing/Printing the media”. To obtain sufficient protection, apply at least 2 coats.

The ambient and object temperatures must be at least +5°C during processing and drying.

Mix well before use.

Too thick a coat and too short drying times between coats can result in wrinkling of the coating surface and prolonged drying times.

Ensure adequate ventilation during processing and drying indoors.

Allow sufficient drying time between coats. The environment of the surfaces to be coated must be covered and protected from

material splashes.

Approx. 90 ml/m2 per coat. Consumption may vary depending on the nature and structure of the support and the application process. Determine the exact consumption values by testing the support.

Dilute with max. 10%. For impact resistance add 5% hardener.

 

Drying

At +20°C and 65% relative humidity:
Surface dry after approx. 2 hours
Recoverable after approx. 12 hours
Drying time is increased at lower temperatures and/or higher air humidity.

Clean tools immediately after use with universal nitrocellulose thinner or brush cleaner.

material.

Approx. 90 ml/m2 per coat. Consumption may vary depending on the nature and structure of the support and the application process. Determine the exact consumption values by testing the support.

Dilute with max. 10%. For impact resistance add 5% hardener.

 

Drying

At +20°C and 65% relative humidity:
Surface dry after approx. 2 hours
Recoverable after approx. 12 hours
Drying time is increased at lower temperatures and/or higher air humidity.

Clean tools immediately after use with universal nitrocellulose thinner or brush cleaner.