COMPLETE CLUTCH KIT FOR JOHN DEERE 330 MM KTEMCJD0025

The KTEMCJD0025 complete clutch kit is designed to replace the clutch on John Deere models when the required configuration includes a 330 mm drive plate, a 330/327 mm dimension, and a 10Z/10Z profile. This kit includes the main components typically replaced during a clutch repair to ensure a consistent reassembly.

A complete kit for clutch rebuild

This part number includes:

• a clutch mechanism,
• a 330 mm pressure plate,
• a clutch release bearing,
• a pilot bearing.

In a clutch system, these components work together between the engine and the transmission. The mechanism applies force to the disc; the disc transmits motion to the drivetrain; the clutch release bearing engages when the clutch is actuated; and the pilot bearing helps guide the shaft, depending on the machine’s specific configuration.

Technical specifications to check before ordering

Dimensions are critical here. The kit is listed with a 330 mm drive plate and a 330/327 mm specification. The 10Z/10Z spline configuration is also an essential selection criterion. For a clutch, the diameter and profile must match the existing installation; a difference in either of these points may prevent the parts from being assembled correctly.

If you are replacing a worn assembly, these values allow you to compare the part number you are looking for with the removed part or with the specifications listed in your maintenance manual. These are the most useful references when the machine is not identified by a detailed model list.

John Deere Application: What We Know About This Part Number

The source associates this kit with a John Deere application. However, no specific tractor model is provided with this part number. Therefore, this compatibility should not be extended to the brand’s entire product line. The correct approach is to simultaneously check part number KTEMCJD0025, the clutch dimensions, and the 10Z/10Z configuration.

This is particularly important for agricultural clutches, where multiple configurations may coexist depending on the series, manufacturing changes, or transmission equipment.

When to Choose a Complete Kit Rather Than a Single Part

A complete kit is generally chosen when the clutch has already been removed and the goal is to replace the main components in a single service call. This prevents installing a new disc alongside peripheral components that are already worn. For this part number, the inclusion of the mechanism, the thrust plate, and the pilot bearing provides a uniform replacement assembly around the drive plate.

Before confirming your order, simply verify that your setup matches the specified part numbers. If you need a 330 mm clutch in the 330/327 mm size with 10Z/10Z, this part number serves as a direct comparison.

Dimensions and Technical Specifications

• 330 mm
• 330/327 mm

FAQ — Frequently Asked Questions

What does the KTEMCJD0025 clutch kit contain?

This kit includes the main components needed for a clutch replacement: the clutch assembly, the 330 mm drive plate, the clutch release bearing, and the pilot bearing. This set allows you to replace the parts typically involved in a clutch repair.

What do the dimensions 330 mm and 330/327 mm refer to?

The 330 mm corresponds to the drive plate included in the kit, while 330/327 mm serves as an additional dimensional reference for the assembly. These values are useful for comparing the removed part and avoiding a selection error before reassembly.

What does the 10Z/10Z configuration mean?

The designation 10Z/10Z refers to the spline configuration specified for this part number. This is an important checkpoint, just like the diameter, because a difference in this specification may prevent proper installation on the relevant shaft.

Is this clutch kit compatible with all John Deere tractors?

No, it should not be assumed to be compatible with all models of this brand. The source associates it with a John Deere application, but without a specific list of models. It is therefore best to verify part number KTEMCJD0025, the dimensions 330 mm and 330/327 mm, as well as the 10Z/10Z configuration.

Original replacement part numbers and brand names are provided for comparison purposes only. This does not imply that these are original parts.